GATE MOTORISATIONS CONCERNED (after 2010):
• EVOLVIA, SGA and PASSEO 800 arm motors
• EXAVIA, SGS cylinder motors
• FREEVIA, SLIDYMOOVE sliding motors
A / Creating the radio control on the monitor interface
• After configuring the monitor, via the welcome screen, press
then
at the centre of the screen.
• Select
depending on your type of gate then the desired channel (e.g.: channel 1) then “Continue “.
• Give your channel a name (e.g: Gate): max. 7 characters.
On the subsequent screens, do not follow the instructions and press directly on “Save” and “Continue” and “OK” .
B Saving the gate motorisation in the monitor’s memory
• Place the monitor (with power supply) next to the gate motorisation
• Open the motorisation cover to access the electronics
• Press on the power button of your electronics for 2 seconds (if this button does not exist, continue directly to the next step). The indicator light
is lit on the electronics.
• Open the command interface of your monitor by pressing
• Place the upper right-hand corner of the monitor on the target of the motorisation electronics.
• Briefly press on the icon
The indicator light
on the motorisation is lit then goes out.
• The motorisation is now saved in the monitor’s memory. You can control the opening and closing of your gate using the wireless control.
For more details, consult section concerning “Adding a 3-button remote control” in the instruction manual of your SOMFY motorisation.